![]() Stud finders work close to no on plaster, but you can find the studs using the magnet trick. Heavy ItemsĪs heavier items need more support, we recommend screwing into a stud with a 2” screw. ![]() For heavy items, you can opt screws with masonry anchors. For lighter items, screwing into the plaster with a 1 1/4” drywall screw can get the job done. Screws are your ultimate option for hanging things on plaster walls without picture rail. Damage may not be visible instantly, but as plaster comes loose from the lath, it will eventually begin to fall off the wall. Hammering nails into a plaster is a quick way to knock plaster loose from the lath that is supporting it. The first thing is to put away the hammer. We still have some great ideas for hanging on plaster walls. If you don’t have a picture rail, it is completely fine. For something too heavy, it’s best to mount it in a more secure way to the wall. Picture rail works great for most decorations, but they are not suitable for hanging extremely heavy items. It is installed to give you a place to hang things like art, mirrors, pictures, and anything else without putting holes in your plaster. Do you have a picture rail?Ī picture rail has a wonderful purpose, and that is to protect your walls. The learning is essential to make the decorating process simpler, and also to avoid costly damage. Like you, almost everyone wants to decorate their walls, so learning how to hang things on plaster walls is important. Everything from finding a stud in plaster walls to the type of fasteners you should use is different for the two types of walls. If you look at pictures of Victorian houses you can often see this type of rail which is called a picture rail and was devised to handle exactly the problem you have.Most of the useful devices for hanging things on our walls were designed for drywall, not plaster. I think the preferred traditional (and safest for your plaster) solution would be to install some type of hanging rail bridging between two vertical supports and lagged into them through the plaster. Unlike a sheetrock wall, lathe is supported by a sometimes irregular patterns of vertical supports, but there vertucals under there. ![]() Depending on the remaining strength of your wall this might work OK. These "keys" are what hold the plaster to the wall any damage to them and your plaster will begin to fail (crack, break into pieces, fall off or sag).įifteen pounds of mirror sounds a bit heavy to try to hang from just your plaster and lathe the usual contemporary solution would be to install special bolts that go through the plaster and lathe and then press back against the back surface to support the item hanging on the front. ![]() If you can find the back of some plaster to look at you will see exactly what I mean. When the plaster dries those pushed-through parts contract and stick, hard, to the back of the lathe forming what are called "keys". When plaster is installed it is sort of a stiffish glop, and it is pressed against the underlying lathe layer some of the plaster is smushed through the openings between the lathe rows. Lathe and plaster are not separate items, but integral parts of your wall. What's behind your plaster is not strapping, but wood lathe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |